Litebar® Technical Data Sheet

The conduit Litebar® LED lighting units are enclosed in either Aluminium, or PVC Plastic conduit.

Aluminium conduit units:

All units are 25mm diameter and are compatible with “off the shelf” electrical conduit fittings. Whether coupled up with plastic or aluminium fittings, all units must be mechanically earthed. Enough extra wiring should be allowed to enable the conduit to be rotated to the desired lighting angle. This should never exceed 180 degrees in either direction. They should always be fixed in position using appropriate clips.

Click here to preview a sketch of an Aluminium unit with a 90° lighting angle and an IP Rating of IP68.

PVC Plastic conduit units:

All units are 25mm diameter and are compatible with “off the shelf” electrical conduit fittings. If coupled up with galvanised fittings, all units must be mechanically earthed. Enough extra wiring should be allowed to enable the conduit to be rotated to the desired lighting angle. This should never exceed 180 degrees in either direction. They should always be fixed in position using appropriate clips.

Click here to preview a sketch of a PVC unit with a 180° lighting angle and IP ratings of either IP20 or IP64.

Lighting strips:

The lighting strips must only be used in the supplied form – as part of the conduit lighting unit.

Input voltage: 12V
DC Rated Power: 60
LEDs per metre = 4.8W per Litebar®
120 LEDs per metre = 9.6W per Litebar®
240 LEDs per metre = 19.2W per Litebar®

Lumens level: See other side for more details
IP Ratings: IP20, IP64 & IP68
Storage temperature: -40C to +80C
Operating Temperature: -25C to +60C

Although it is not recommended that the units be shortened in length, if they were to be shortened, then the lighting strips must be cut along the marked cutting lines.

Safety compliance:

The Litebar ® units and their component parts have been tested both above and below water * for over three years in challenging climatic conditions – and have shown no noticeable degradation, or potential safety hazards. As they are only 12v, they are exempt from all relevant EU Directives. That said, the drivers / transformers to which they’re connected, MUST be CE compliant and display a stamp or certificate similar to that shown below.

* Only Litebars ® with IP68 LED lights can be used under water – and are guaranteed to a maximum depth of five metres.

End of life disposal:

All products should be disposed of responsibly. The various versions of the Litebar ® consist of two of three parts – Aluminium, PVC and silicone coated lighting. Both Aluminium and PVC are 100% recyclable. Regarding silicone, although there are specialist recycling companies (see our website), we recommend landfill or incineration.

For further information on Sustainability Assessment of Novel LED Lighting Technology: click here!